Skip to content
ParkingNerdHelp

Scan a plate

Point your phone at a car, wait for the buzz, read the card, then tap Scan next.

Everyone on your teamUpdated November 16, 2026

Scanning reads a car's plate with your phone's camera and checks it with ParkingNerd.

  1. Tap the Scan tab. Check that the name at the top left is the lot you're working.
  2. Point the camera at the car's license plate. The screen says Point at a license plate., and Looking for a plate… shows at the bottom while it searches.
  3. Hold the phone steady. When the app has read the plate, the phone buzzes and a card appears.
  4. Read the card (see below).
  5. Tap Scan next and point at the next car.

What's on the card

  • The plate in large letters, exactly as the app read it.
  • State unknown: the app doesn't read the state from the plate.
  • A small photo of the car, when the app took one.
  • The check. While the app asks ParkingNerd, the card shows Checking with ParkingNerd…. Then a colored status badge appears, with a line of detail under it.
  • How long the read took, for example "Read in 1.2 s".
  • Scan next, to clear the card and read another car.

If the check can't finish, for example because you have no signal, the card shows a message in red and a Retry button instead of the badge. See Scanning with poor or no signal.

While the card is showing

The camera stops picking up new plates until you tap Scan next. A car driving past won't replace the card you're reading.

After you tap Scan next, the app won't read the same plate again until it has been out of view for 2 seconds. So if the car you just checked is still in front of you, the app waits for the next one. To read the same car again, point away for a moment, then back. More in Tips for better plate reads.

Good to know

  • The screen stays on while the Scan tab is open, so it won't lock in the middle of a walk around the lot.
  • The camera turns off when you leave the Scan tab or switch to another app, and turns back on when you return.
  • Every plate you read goes into the History tab. See Your scan history.

Still stuck?

Ask your Owner or an Admin first. They set up the app for your lot. You can also email ParkingNerd support at [email protected].