Skip to content
ParkingNerdHelp

Allow camera access

The Operator app needs your phone's camera to read plates. Here's how to allow it, and how to turn it on later if you said no.

Everyone on your teamUpdated November 16, 2026

Allowing camera access lets the ParkingNerd Operator app read license plates.

  1. Tap the Scan tab. Until the camera is allowed, it shows Camera access needed and "ParkingNerd Operator reads license plates with the camera."
  2. Tap Allow camera.
  3. Your phone asks whether the app may use the camera. On an iPhone, the question says "ParkingNerd Operator uses the camera to read license plates." Allow it.
  4. The Scan tab switches to the camera, ready to read a plate.

If you said no

Once your phone won't ask again, the button changes from Allow camera to Open Settings.

  1. Tap Open Settings. Your phone opens its settings page for the app.
  2. Turn on the camera there.
  3. Go back to the app and tap the Scan tab.

On an iPhone, this happens after a single "no": from then on, the camera can only be turned on in Settings.

When the camera is on

The app uses the camera only while you're on the Scan tab. It turns the camera off when you:

  • switch to the History or Settings tab,
  • open the Type a plate sheet, or
  • switch to another app or lock the phone.

It turns back on when you return to Scan.

Next

Scan a plate

Still stuck?

Ask your Owner or an Admin first. They set up the app for your lot. You can also email ParkingNerd support at [email protected].