Skip to content
ParkingNerdHelp

Connect the app to your lot

Type your lot code or scan its QR code to connect a phone. There's no sign-in.

Everyone on your teamUpdated November 16, 2026

The Operator app has no sign-in. Instead, each phone connects with your lot's code. Your Owner or an Admin gives you the code, or shows you its QR code from the ParkingNerd operator portal.

  1. Open the app. Until the phone is connected, it opens on the screen headed Scanner for parking operators.
  2. Type the code in Lot code and tap Connect. Or tap Scan QR code and point the camera at the lot's QR code.
  3. Wait while it says Connecting…. Once it's connected, the app opens on the Scan tab with your lot's name at the top.

The phone stays connected when you close the app. You only connect again after you disconnect it or the code is reset.

If it doesn't connect

MessageWhat to do
Enter the lot code.The box is empty. Type the code, then tap Connect.
That code didn't work. Check it and try again.Check each character with your Owner or Admin. The code may also have been reset.
Couldn't reach ParkingNerd. Check your connection.The phone has no signal or Wi-Fi. Move somewhere with a connection and try again.
That QR code isn't a ParkingNerd lot code.You scanned a different QR code. Point at your lot's code from the operator portal.

Scanning a QR code needs the camera. If the app can't use it, see Allow camera access.

When the code is reset

Your Owner or an Admin can reset your lot's code, for example when a phone is lost or someone leaves. Resetting disconnects every phone that connected with the old code. Each phone goes back to the connect screen. Ask your Owner or an Admin for the new code, then connect again.

Still stuck?

Ask your Owner or an Admin first. They set up the app for your lot. You can also email ParkingNerd support at [email protected].