Scanning with poor or no signal
The app reads plates without signal, but checking them needs a connection. Use Retry on the card when a check fails.
Everyone on your teamUpdated November 16, 2026
The ParkingNerd Operator app reads plates without signal, but it needs a connection to check them with ParkingNerd. Here's how to finish a check that failed.
- When a check can't finish, the card shows a message in red and a Retry button.
- Keep the card open. Don't tap Scan next yet.
- Move somewhere with better signal, or connect to Wi-Fi.
- Tap Retry. The card shows Checking with ParkingNerd…, then the result.
- Tap Scan next and carry on.
What works without signal
- Reading plates. The camera reads the plate on the phone itself, so you still get the buzz and the card.
- Typing plates. The Type a plate sheet works as usual.
- History. Every read is added to the History tab.
- Staying connected. Opening the app without signal doesn't disconnect it from your lot.
What needs a connection is the check itself: the part of the card that shows Checking with ParkingNerd… and then the result.
Messages you might see
| Message | What to do |
|---|---|
| Couldn't reach ParkingNerd. | The phone has no connection, or ParkingNerd took too long to answer. Get better signal and tap Retry. |
| ParkingNerd's reply didn't make sense. Try again. | This can happen on Wi-Fi that wants you to sign in first. Sign in to the Wi-Fi or turn it off, then tap Retry. |
Retry only works on the card
The app doesn't try a failed check again by itself, and it doesn't save checks to send later.
Related articles
Still stuck?
Ask your Owner or an Admin first. They set up the app for your lot. You can also email ParkingNerd support at [email protected].